Incredibly, the Ford seller couldn't answer me this question and the owner's manual isn't clear as well: while it says that "When you select position S, a gear change may occur depending on the accelerator pedal position in relation to actual vehicle speed" - thus implying that it can, indeed, be changed while moving - it also clearly says to Hello friends! I have problem with Mondeo MK4.. On this car was gearbox exchange from automatic (powershift) to manual and now on ECU have fault with no communication with ecu anybody can help me? ECU: Delphi DCM 3.5 HW: BG91-12A650-SJ SW: BG91-14c204-FJ I think only what I need to new software from manual version Anybody can help me? BR Milage is 81500, gearbox was serviced by Ford dealer two years ago. Oil and filter were changed by gearbox specialist this time no reports of contamination or other issues. Will have a look at the other threads to see if anyone else had similar problems. Replaced the clutch master cyclinder, not a big job just in behind the clutch pedal, and this cured it. Have posted in a few threads on this forum and on TalkFord about it if you do a search. Quote. 656. Posted April 10, 2013. On 4/10/2013 at 3:53 AM, Avenger1978 said: when engine is cold i have noticed changing gears is abit stiff to the The actuator should only move when the engine is started. It is the actuator (little black box) which controls the positioning of the variable vanes inside the turbo. When the engine is switched off, the actuator will push rearward, and when the engine is switched on, the actuator should pull forward. Here’s more on Ford Mondeo bad fuel injector diagnosis. Not Enough Fuel – The fuel pump may not be able to provide the fuel pressure needed for the engine to run properly. When it asks for a lot of fuel, instead of taking off, it stalls out with the demand. This can be caused by the fuel pump or fuel filter. Disconnect the wire for the parking sensors from the reverse light and see if they work. If on your car the reverse light circuit is controlled by the BCM then it may be sensing the increased current draw and is switching off the supply to the lights. I already tried removing the parking sensor's connection completely. We Offer a Repair Service to Ford Mondeo MK4 Convers+ Instrument Clusters. Some of the common problems found on these instrument clusters are listed below • Intermittent Power Issues •Radio and Temp/Climate Not Working • Needles/Guages Sticking • Total Power Failure • Intermittent power failure The second gearbox on the ford mondeo mk5 2l diesel from 2015-2022 that has developed a bad bearing noise, in this video i take the gearbox apart to find the GO3HUk.

ford mondeo mk4 gearbox problems